DIY LED Lightsaber Tutorial | 1:12 Scale Darth Vader

0 Просмотры
Издатель
Description

#StarWars #Vader #Tutorial

A few months ago, I made a book nook featuring Vader in the hallway from Rogue One. I used an LED filament from a high voltage lightbulb to create the lit lightsaber effect. This is obviously quite dangerous so I waited until I had a safer, low voltage option to put out a tutorial for you all. Many of you asked, so here it is. Thanks for your patience! I hope you enjoy and go on to make little lightsabers to your heart’s content.

These lightsabers are at the 1:12 scale which will fit with Bandai figure kits and 6” Hasbro Black Series figures. If you have any questions, let me know in the comments and I’ll help how I can!

My other Vader Build:

Materials:
Bandai 1:12 Darth Vader
3V LED Filaments (130mm)
LED Tape
Slotted Aluminum Sheet
Opaque Acrylic Sheet
Solder
Heat Shrink Tubing
Copper Wire
Plastic Cement
Super Glue
Masking Tape
.040 Styrene
.020 Styrene
Old Frame (Thrift Store Find)

Supplies:
Safety Glasses
Hand Drill/Pin Vice
X-Acto Z Series
Utility Knife
Ruler
Nippers
Wire Cutters
Tweezers
Paint Brushes
Helping Hands
Soldering Iron

Paint:
Rust Olium Flat Black

Music:
Autumn Wind - Dyalla
Nobody Home - Dyalla
Le Freak - Rage
Giant iPhone - Rage

Disclaimer: Some of the actions seen in my videos could cause bodily harm. I am not responsible for anything you do while attempting to recreate what you see me do.

Amazon Affiliate links are used above.
Категория
Приключения
Комментариев нет.
Яндекс.Метрика